The P.E.S. Power Box can also be opperated on a 9 Volt Alkaline Battery
--------------------------------------------------------------------------------
On/Off - This switch turns the Power Box on and off. The switch should be in the off position before inserting, applying, or removing electrodes.
Coarse Power Adjustment - This is the primary power adjustment. This knob and the Fine Power Knob should be on 1 when the box is turned on, and then increased as needed. ( in some configurations this knob may increase to 9 or 10 before the sensations are felt)
Fine Power Adjustment - This is the fine tune adjustment for the coarse power adjustment. It will increase the power at a slower rate.
Pulse Adjustment - This control knob adjusts the pulsations of the current and should be set at 10 before turning on the power. It produces a steady pulse when set at 10 and a very slow pulse when set on 1.
Coarse Frequency Adjustment - This control adjusts the frequency of the current and should be set at 10 when the box is turned on. It produces a sharper or softer feel of the current and is a very important feature in achieving a hands free ejaculation.
Fine Frequency Adjustment - This control is a "thumb wheel" found on the right hand side of the P.E.S. power box and is a critical part of the frequency adjustment.
LED Indicators - These indicator lights will illuminate when the power is on and will flash intermittently to the rate of the pulse.
Channel A & B Lead Connections - These connections are found at the top of the P.E.S. Power Box and is the location where the Low Profile leads connect.
Channel A & B Power Interrupts - These two push buttons found on the front of the P.E.S. Power Box interrupt the power sent to the electrodes when depressed and return the current flow when released. (note: the power control should be turned to 1 or the power box turned off before releasing the buttons.
P.E.S. TECHNICAL INFORMATION:
The Low Profile Leads use pinch technology on snap electrodes attachments. This is a very lightweight lead that is compatible with all snap electrodes on P.E.S. products. The Low Profile Leads have spreader clasps which adjust the lead lengths. This is especially helpful when using more than one P.E.S. device at one time.